Polyetheretone Ketone Powder
We are a manufacturer based in China. We specialize in providing high-quality Polyetheretone Ketone Powder for industrial clients across various sectors. Whether you need chemicals consultation or technical support, our team is here to help.
Category：Polymer materials Own Brand：MT /MOQ:100KG /From China/ B2B only.
Introduction
PEKK powder can be used for carbon fiber prepreg,high-grade non-stick pan coating,chemicaland pharmaceutical corrosion resistence coating,3D printing additive manufacturing,epoxyresin toughening agent,carbon fiber sizing agent and other plastic processing additives,lithiumelectric film coating,etc.It is suitable for electrostatic coating,heat-press molding,SLS additivemanufacturing and other processing methods.
PEKK powder product series profile
| Project | Unit | Testing method | CC 5601-50/20 | CC 5801-50/20 |
| General performance | ||||
| Density | g/cm³ | ASTM D792 | 1.28 | 1.28 |
| MFR@380℃,5Kg | g/10min | ISO 1133 | ≥80 | 30-50 |
| Mechanical properties | ||||
| Tensile strength | MPa | ASTM D638 | 90 | 90 |
| Tensile modulus | GPa | ASTM D638 | 3.1 | 3.1 |
| Elongation at break | % | ASTM D638 | ≥100 | ≥200 |
| Flexural strength | MPa | ASTM D790 | 120 | 120 |
| Flexural sodulus | GPa | ASTM D790 | 2.5 | 2.5 |
| Thermal performance | ||||
| Glass transition temperature(Tg) | ℃ | DSC | 155 | 155 |
| Meltingtemperature(Tm) | ℃ | DSC | 305 | 305 |
suitable for the needs of market and customer.Please consult the product manager for details.
▶Electrostatic coating processing guide
| Product Code | 5601-50/20 |
| Particle size(D50,μm) | 50/20 |
| 1.All sharp edges and burrs on the metal surface should be removed in order to avoid pin holes in the coating. | |
| 2.First degrease the metal part with surface agent or heating,and then sand blast the metal surface with clean alumina sand . | |
| 3.The clean treated substrate must be heated to 320~350℃ for about 1 hour before first coating,to apply coatings evenly,flow out the coating at 320~350℃.The coating time should be limited to 10 mins for every layer.Powder coating must be stop if there is white unmelting powder deposited on the surface,the oven temperature should never be below 320℃. | |
| 4.Repeat the above step 3 until the target thickness is reached,and then cool to room temperature finally. | |
| 5.Then carry out for quality detection,and finally put into storage for delivery. | |
■The above data are typical values of products and cannot be used as product acceptance criteria.
■The final product will be affected by various factors such as working conditions.The values shown in the product introduction
If you're ready to take the next step, Leave your message below and we’ll reply soon. 20+ years of chemical manufacturing & export experience, a partner you can trust.
Inquiry
Factory & Shipment
